Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need parameters for PA design with FR4 substrate

Status
Not open for further replies.
B

bouchy

Advanced Member level 4
Full Member level 1
Joined
Jul 11, 2004
Messages
113
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
USA
Activity points
794
Hi All,

I designed a linear PA for my school project. However I am experiencing problems with the test board layout using Autocad. I am trying to use FR4 substrate, but I don’t know the thickness of each layer, the size of via and component dimensions (cap, inductor..)…Can someone please give me some advise, or if someone can share some project that will be helpful.

Thanks in advance,

bouchy
 

Re: PA design

is your plan to use the multilayer or single layer board?
what is your power rate?
why use fr-4,although it is cheap,but i think y will meet a lot of problems!
 

    B

    bouchy

    Points: 2
    Helpful Answer Positive Rating
Re: PA design

this is a 1w PA and I am planning to use 4-layer board. At this stage I am looking at different substrate; fr-4 is one and GETEK is another. If someone has any layout for me to use as guideline, or to get me started I will appreciate it very much.

Thanks

Bouchy
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top