Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Some FET parameters question

Status
Not open for further replies.

saturn

Member level 1
Member level 1
Joined
Jul 3, 2004
Messages
32
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Location
Solar System
Activity points
267
idss fet

Hello,
What is the meaning of Idss (Zero-Gate Voltage Drain Current) of a FET. Is it the smaller the value, the better the FET?

Also what is Vgs, the smaller the better?

Thanks & best regards.
 

fet parameters

Idss ia a current when Vgs=0V.
Value is just different for different FETs and do not descibe the transistors quality ..
With Vgs you probably mean Vgsoff which is a Vgs voltage at which Id=0 (or near to). Again, different value for diffrent transistor with no preferences ..
 

    saturn

    Points: 2
    Helpful Answer Positive Rating
fet idss

Thanks! Ian.

Still I didn't get much from what you said. For example Idss (as you mentioned when Vgs=0V). In this case, the FET is off, right? Then an ideal FET should have Idss=0?
 

idss in fet

At Vgs=0 FETs conduct certain current: for example the popular BF245C has Idss=12mA, but BF245A has only Idss=2mA.
As I mentioned befor FET is off at Vgsoff what can be for N-FET somewhere below -5V and varies fro differen FETs.
 

    saturn

    Points: 2
    Helpful Answer Positive Rating
fet parameterts

saturn,

A depletion mode junction FET is ON with Vgs = 0. Under this condition, the drain current is relatively independent of the Drain-Source voltage.
This is the Idss.
Idss is not a measure of quality. It is a measure of the maximum current that you can expect the FET to support.

Vgs, or Vgsoff is the magnitude of Gate-to-Source voltage that is required to turn the FET OFF. It is given for a maximum Drain current, e.g., 200uA, and a specified Drain-to-Source voltage, e.g., 10V. For an N-channel depletion mode junction FET, Vgsoff is negative; for a P-channel FET, it is positive. Vgs is not a measure of quality.

For a given family of FETs, the higher the Vgsoff is, the higher will be the Idss.

For a given family of FETs, the higher the Idss value, the lower will be the rdson (drain-to source resistance). The rdson parameter is usually only specified for FETS that are intended for switching applications.

Regards,
Kral
 
  • Like
Reactions: shelsd96

    saturn

    Points: 2
    Helpful Answer Positive Rating

    shelsd96

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top