Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes it is checked andre!
But I found it!
I knew that I should check "pad hole" and "via hole" somewhere to make them visible.
I had looked at View Configuration several times before but I couldn't find them.
After you referred me to this panel again I found their locations accidentally.
They were collapsed under "system colors" as shown in picture below
As I click on it the picture below appears and I can check them
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
