Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] PTM-MG hspice model for finfet

Status
Not open for further replies.
Just search in the model card!
 

As i said nfin is number of fins not number of fingers hh.PNG
 

Misunderstanding on my part, sorry!

As the NF parameter isn't fixed in the model file, I think it's your choice - as long as you think you won't exceed a certain wmax value, which isn't given as well. Many model files limit their validity/accuracy not only for min/max length (like in this case), but also for the width (or rather drain current).
 
From what I have seen, in FinFETs, each finger is recognize as a separate instance, so NF=1.
 

how can u say that it is finfet model...
this is multigate nfet model.
 

GayatriGaikwad said:
how can u say that it is finfet model...
this is multigate nfet model.
Click to expand...

It's a FinFET or Vertical Gate FET not because of the number of gates, but because the gate is raised, you have two, three, or even four areas of the gate available for inversion to transport charge compared to a single region in planar cmos.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top