Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] HFSS: Two different materials intersecting error

Status
Not open for further replies.
mishrashashi

mishrashashi

Advanced Member level 4
Full Member level 1
Joined
Jan 5, 2011
Messages
105
Helped
20
Reputation
40
Reaction score
20
Trophy points
1,298
Location
India
Activity points
1,912
I am simulating one connector in HFSS. I have assigned different materials for pins (Copper alloy) and body (Polyester). While validating, I am getting error of intersection. How to remove or ignore this error? please help. I'm new in HFSS.
 

check the dimensions of the pins carefully...even a fractional of interconnection results in error in HFSS
 
The problem is that the pin and dielectric overlap and the simulation does not know which material to use in the overlap. Subtract the pin (save the object ) from the dielectric. Now there should be no ambiguity between pin and dielectric. You could also set "material override" so conductors take precedence. I am usually vey careful when I have conductors in a simulation rather than PEC.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top