Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

p10 led module interface with pic

Status
Not open for further replies.
R

raman00084

Full Member level 6
Full Member level 6
Joined
Nov 29, 2010
Messages
375
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,076
i want to interface p10 single colour led module 16x32 with pic micro. any sample code kindly help

i cannot get the schematic for p10 if any one have kindly send.

how much io will p10 led module need with pic
 

Thank you. If i am using 4 modules then also the io will be 6?
 

Hi,

Without knowing anything about your module...I assume you need individual OE for each module.
OE, or better say CS will be low-active.

A 74HC138 (or similar) may reduce microcontroller pins and additionally avoid that accidentally two or more modules can be selected at the same time.

Klaus
 

no need more io for 4 module OE,STB,CLK,A,B are parallel and data is in cascade mode
P10 module is 1/4 scanning (4 ROW SCAN ONE TIME)
PIN A B
0 0 ROW 1,5,9,13
1 0 ROW 2,6,10,14
0 1 ROW 3,7,11,15
1 1 ROW 4,8,12,16
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top