Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A cavity simulation in HFSS

Status
Not open for further replies.
B

bin123

Newbie level 4
Newbie level 4
Joined
Oct 29, 2016
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
50
Hello, i'm a student came from china, now i have a question about S11 parameters in HFSS, why my s11 value is -0.000035dB but not -20dB when it come to resonate frequency 1MHz. are
there some problem in my soft setting?
1.PNG
 

Hi, i do not have a exact solution for your problem while only have this picture that you posted. If you can send more designing information with this antenna, i would like to help you.
 
  • Like
Reactions: bin123

    B

    bin123

    Points: 2
    Helpful Answer Positive Rating
I also had many problems with HFSS and cavity simulations with my master thesis.
I finally succeded at simulating a cavity but not a cavity filter :(
It may be problem of the port definition... I attatch you the cavity I made with S11 simulation at -3db at the resonating point and the other is the eigen simulation. You could try that too.
I also attatch you my master thesis and hope to be helpful for you.

https://ddd.uab.cat/record/148404?ln=es

https://mega.nz/#!rN9BURxZ!JnLeGapomZ3E3K3iP5mkL9L0H6Ogxm07uiloLhdpCMM
 
  • Like
Reactions: bin123

    B

    bin123

    Points: 2
    Helpful Answer Positive Rating
By_Delly said:
Hi, i do not have a exact solution for your problem while only have this picture that you posted. If you can send more designing information with this antenna, i would like to help you.
Click to expand...

thank you so much, finally i have figured my issue out. it's the mismatch problem, when i add an another port and use drive model method, then i succed
 

thank you every one who help me, in the end i figure my problem out by drawing another new port as a match port
123.JPG
 

DavidZlavan said:
I also had many problems with HFSS and cavity simulations with my master thesis.
I finally succeded at simulating a cavity but not a cavity filter :(
It may be problem of the port definition... I attatch you the cavity I made with S11 simulation at -3db at the resonating point and the other is the eigen simulation. You could try that too.
I also attatch you my master thesis and hope to be helpful for you.

https://ddd.uab.cat/record/148404?ln=es

https://mega.nz/#!rN9BURxZ!JnLeGapomZ3E3K3iP5mkL9L0H6Ogxm07uiloLhdpCMM
Click to expand...

i have browsing your paper and thank you, i am a postgraduate and my major is about accelerator cavity loaded by ferrite. i wish we can futher exchange about HFSS
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top