Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do you set grids in Altium library and schematic

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
How do i set the grids (visiable and snap) to 0.1 inch in the library program....how do i change the units to inches.
 

How do i set the grids (visible and snap) to 0.1 inch in the library program
Click to expand...

press G, then enter your desired grids.

how do i change the units to inches
Click to expand...

press Q to toggle between imperial and metric
 
Last edited by a moderator:
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Thanks, but in the library editor, i set all the grids, electrical, snap, and visible to 0.1 inch, and then the screen grid lines are 10 apart....i am not sure where the 10 comes from when i selected 100 thou (0.1 inch)
 

did you zoom in enough to actually see the grid spacing? If you are zoomed out, it can look different.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top