Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Diode to reduce voltage?

Status
Not open for further replies.
C

Cambo

Junior Member level 1
Junior Member level 1
Joined
Sep 18, 2012
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,418
Hi,

I'm currently working on a project that requires both 5V and 3V7 with a max current demand of about 2A - I'm wondering if it's acceptable to simply reduce the 5V by placing a diode inline to the 3V7 input? Perhaps there is a better way of doing this? I have tried an adjustable buck boost regultor but the noise seems to be causing me problems.

Thanks for any advice.
 

You might as well use a linear regulator which has some kind of control rather than a diode which does not. They would both be dissipating the same power.

Rob.
 
  • Like
Reactions: Cambo

    C

    Cambo

    Points: 2
    Helpful Answer Positive Rating
Thanks Brushhead - are you able to suggest a suitable voltage regulator to try?
 

Thanks - for all those with a similar question to this a couple of regulators to look at are: MIC29302 & LM317
 

The LM317 has two pitfalls:
It has only a guaranteed 1 amp current output.
It won't regulate to 3.7v with only a 5v overhead.

The LT1529 may be a better option
 
Simple transistor and zener regulator. (The zener can also be a combination of diodes/ led's/ resistors.)

5867255400_1465357691.png


Bias current goes through the load, so it may not be satisfactory with every load.
 

Thanks folks, that's really helpful.

Good call on the LM317, two oversights on my part!
Thanks for the transistor method too, do you have any values for the resistors? I will try both methods and learn something :)
 

Cambo said:
Thanks for the transistor method too, do you have any values for the resistors?
Click to expand...

The transistor must dissipate 2.6 W. The resistor value depends on your transistor gain. It must be low enough to supply sufficient bias to turn on the transistor.

My simulator has transistor gain of 100. If your gain is greater, then the resistor value can be greater.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top