Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to handle Xilinx virtex5 Vccint?

Status
Not open for further replies.
U

u24c02

Advanced Member level 1
Advanced Member level 1
Joined
May 8, 2012
Messages
404
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,101
Hi.
I'd like to supply the voltage to Xilinx Virtex5 Vccint.

And I found the some texts as belows.

Virtex-5 FPGA DC Characteristics
0
Virtex-5 FPGA Data Sheet:
DC and Switching Characteristics
DS202 (v5.4) December 4, 2014 0 0 Product Specification
Table 1: Absolute Maximum Ratings
Symbol Description Units
VCCINT Internal supply voltage relative to GND –0.5 to 1.1 V

I think it should be supplied 1.0V. But the problem is that main board's input voltage level is 5V 2A. So I think that I need to voltage drop.

Does anyone know what should I do for handling for this problem?

Generally, How to handle Virtex5's Vccint?
 

The 1.0V supply is (on larger FPGAs) able to draw up
to 10A or so. You want a well implemented DC-DC (I'd
recommend one of the single chip buck converters out
there, like from TI or Intersil, LTC or maybe Maxim. You
sure do not want a linear regulator. And you had better
consider going bigger on the 5V feed because 1V@10A
at 100% efficient would account for all of your 5V, 2A.

I'm relatively confident that Xilinx has their own set of
recommendations for you, in app notes if not a fully
blessed go-buy-it partner solution.
 

u24c02 said:
Virtex-5 FPGA Data Sheet:
DC and Switching Characteristics
DS202 (v5.4) December 4, 2014 0 0 Product Specification
Table 1: Absolute Maximum Ratings
Symbol Description Units
VCCINT Internal supply voltage relative to GND –0.5 to 1.1 V
Click to expand...

Why are you looking at the Maximum Ratings? You should be using the "Table 2: Recommended Operating Conditions" data for your design.
VCCINT
Internal supply voltage relative to GND, TJ = 0°C to +85°C Commercial 0.95 1.05 V
Internal supply voltage relative to GND, TJ = –40°C to +100°C Industrial 0.95 1.05 V

I predict the release of magic smoke from a Virtex-5 in the future. ;-)
 

As dick_freebird cited, the single answer is: use a +5.0V to +1.0V DC/DC converter circuit integrated to your board. You must dimension the DC/DC converter output current as well (you may require more than 2A from 5V line only for this line!)

You must be sure this voltage is very stable and noiseless. A DC/DC converter kit from a common vendor (TI, Maxim) may be a good choice in your case, given the Virtex components use to be very expansive.
 
  • Like
Reactions: u24c02

    U

    u24c02

    Points: 2
    Helpful Answer Positive Rating
What you mean the magic smoke?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top