Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the attached diagram of a section wound LLC transformer, what does the width of the “separator” have to be between the primary and secondary coils?
(the LLC converter is the isolation stage of a 230VAC main converter)
thanks, if i put a layer of tape stuck across the top of that barrier tape, then that effectively closes off the route between the primary and secondary coils, and then the actual separation is the creepage along that tape surface , which would be well more than the regulatory 6mm?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.