Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

i use pic16f676 ic and triac for fan speed controlling

Status
Not open for further replies.
J

jayesh9714

Newbie level 1
Newbie level 1
Joined
Apr 1, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
Hello
Friends
Please help me any one.

my hardware is complete and ok.
But my programming of program in few misteck.

I have use pic16f676 ic and bta12 triac.

All applice can be ob/off.
But
When
I connected Fan that time fan will not start.but only doing harmming of fan.
I have also apply zero cross detection In program
And i also use pwm base singal

Thus for that
when i start my device on/off bey nec remote,that fan will not start and system is hange.
Please give me solutions of programing
I also use el3021 opto copler.

Please help me
Thanks
 

I used a triac in my homebrew fan speed control. The fan was a 'squirrel cage' type (mounted on a wood stove). The type is important. As I understand it, most fans cannot be speed-controlled by a triac, with their rpm dependent on the frequency of the AC supply.

If you simply limit power (as with a triac), the normal fan tries to spin at full frequency. When you continue to reduce power, there comes a point where it doesn't spin at all. I guess that's when you get only the humming noise.

Ceiling fans are a different animal. You may be able to control one of those with your pic.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top