Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] HFSS Port Refinement, process hf3d error

Status
Not open for further replies.
S

srijan.rio

Member level 2
Member level 2
Joined
Mar 7, 2016
Messages
50
Helped
2
Reputation
4
Reaction score
1
Trophy points
8
Activity points
484
I am a brand new to EM simulation. I have started using HFSS13 for a college project and I need to design a differential microstrip antenna. When I tried to run the simulation, I am getting the error "Port refinement, process hf3d error: Terminal T1 on port p1 contains a non-conducting edge. The terminal may need to be assigned manually" even though the edges of terminal T1 has been made a conductor.

I have gone through other threads in here with this error but couldn't get a definite solution. Can anyone kindly suggest what may be causing this Problem. I have attached the hfss file.

Thanks
 

Attachments

  • Verify.rar
    37.9 KB · Views: 372

Are you sure? It looks like terminal 1 is just the outline of the face of trace 1, which is FR4 epoxy, not a conductor. I'm more familiar with driven modal than driven terminal solutions, but I don't think it likes assigning a terminal on the epoxy.
 
@kthackst

Thank you for your response. As you pointed out correctly, using FR4 Epoxy as material of the traces was wrong. So I changed it to copper, and by that the ports were automatically detecting the available terminals. But now a new error is popping up : Port refinement, process hf3d error: Too few conductors were found on port p1. There should be one conductor for each terminal, with one additional reference conductor. Unintentional contact between conductors may cause this error. . (file attached)

I researched some more and found out that the error may be occurring if the line of integration doesn't touch both the conductors. Can you please suggest a solution for this ? (driven modal or driven terminal anyone).
 

Attachments

  • Verify.rar
    38.1 KB · Views: 296

Its solved now. The second error was coming due to non assignment of reference conductors for the terminals to the port. In the design, the Ground_Plane_B and the Bottom_Patch should be used as reference conductors for the terminals of the traces T1 and T2.

Thank you @kthackst for your help.

Best Regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top