Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Overvoltage protection one chip solution?

Status
Not open for further replies.
J

Jester

Full Member level 6
Full Member level 6
Joined
Aug 18, 2012
Messages
377
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Location
.
Visit site
Activity points
4,754
I want to add over voltage protection to a 5.2V, 2.5A SMPS.

I'm looking for minimum parts count and cost, the circuit could be a one time only type circuit.

This device would be ideal if it had a slightly higher current rating: https://www.digikey.ca/product-detail/en/NCP349MNAETBG/NCP349MNAETBGOSCT-ND/3462393

There is a higher current variety in this family, however the 5V, 3A version does not appear to be stocked anywhere.

Any suggestions?
 

analog devices or maxim may do something, even linear.com
Otherwise just use a res divider, comparator, and p channel fet
 
  • Like
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
You can use TL431, it's a comparator with a ref zener. You will also need P chnl mosfet and 2 resistors to set the voltage.
 
  • Like
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
yes, indeed, or indeed the TLV431 which has a lower ref voltage and less bias current draw.
However, the bias current can be a problem as if the cct isn't done right then youll end up with the pfet on when you don't want it on,
 
  • Like
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top