Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] design data logger? interface PIR sensor, EEPROM, LM75 Temp sensor, ATMEGA 16

Status
Not open for further replies.
P

Prakash.143

Junior Member level 1
Junior Member level 1
Joined
Nov 24, 2015
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
165
Hello,
I want to interface PIR sensor, EEPROM, and LM75 Temperature sensor with ATMEGA 16 microcontroller and i have problem in coding.
 

How can i will interface RTC chip with ATMEGA 16 microcontroller?

Hello,
I want to interface an I2C RTC ship with ATMEGA 16 microcontroller for designing digital watch which can show date, week, month, year and i have problem in programming.
 
Last edited by a moderator:

Re: How can i will interface RTC chip with ATMEGA 16 microcontroller?

in which part of code your problem is?
you should firstly connect a 32kHz crystal to the TOSC pins
problem may be in initialization
When the AS2 bit in the ASSR Register is written to logic one, the clock source is taken from the Timer/Counter Oscillator connected to TOSC1 and TOSC2
ASSR=1<<AS2;

you should adjust the clock value and Modes of Operation
Ex.
// Clock value: PCK2/32
// Mode: CTC top=OCR2A at 1E(any value)
TCCR2=(0<<PWM2) | (0<<COM21) | (0<<COM20) | (1<<CTC2) | (0<<CS22) | (1<<CS21) | (1<<CS20);
OCR2=0x1E;

if initialization is right ==>> problem in code so i need to read it
 

    V

    Points: 2
    Helpful Answer Positive Rating
Re: How can i will interface RTC chip with ATMEGA 16 microcontroller?

Hi,

It is very common to use an RTC. I2C also is very common.

Where exactely do you see the problem?

Without detailed informations it is impossible to help.

Klaus
 

- - - Updated - - -

Hi,

Where exactely do you see the problem?

Without detailed informations it is impossible to help.

Klaus
 

How can i will send the data from I2C data register to LCD and EEPROM
 

Re: How can i will interface RTC chip with ATMEGA 16 microcontroller?

This morning I found some one wrote about a problem in writing code for real time clock using ATmega16 chip
there was little information about his problem so I wrote the above replay
and now his question disappeared and my replay shown as a first post !!
I don't understand what happened.
 

This morning I found some one wrote about a problem in writing code for real time clock using ATmega16 chip
there was little information about his problem so I wrote the above replay
and now his question disappeared and my replay shown as a first post !!
I don't understand what happened.
Click to expand...
This happened because you answered while I moved the first post a similar thread started by the OP a few minutes before. Now both threads are finally merged. Sorry for the confusion.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top