Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

STA interview question: about GBA_mode VS PBA_mode timing

Status
Not open for further replies.
W

WatchFish

Newbie level 2
Newbie level 2
Joined
Oct 4, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
13
Hi All,

I have 2 questions got from an interview. I did not find any answers online and hope you could help.

1. After the timing is fixed in PBA mode, can it be tapeout then? Or it needs some extra step?
2. If using GBA mode to do timing closure, it is pessimistic. Is there any negative impact?

Any thoughts are welcome. Thank you very much!:smile:
 

1. Once timing is fixed, we need to verify formality, DRC caused due to new routing patterns, Signal EM and also IR drop. If all the verifications are through, then we can tape out. If your design has different power domains, we might have to a special MVRC (Multi Voltage Rule Check) check as well.

2. Only negative impact is increased number of violations to be fixed.
 
Thank you very much! But is it any other concern about timing? Since the timing is fixed in PBA mode.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top