Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

s parameter problem on cst 2010

Status
Not open for further replies.
S

Satyajit Banerjee

Newbie level 1
Newbie level 1
Joined
Aug 4, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
everytime i changes frequency range, s1,1 curve also change......
why this is so??? tjis create problem in getting the exact result....
 

What is your center frequency?
How about fixing center frequency in your setup? I think that CST will use the center frequency for meshing. Therefore, if you change it, the result will change a little bit.
For example, your frequency range is 100 - 300 MHz. The center frequency is 200MHz.
So, just change the frequency range like 50 - 350 MHz, and so on.
 

Satyajit Banerjee said:
everytime i changes frequency range, s1,1 curve also change......
why this is so??? tjis create problem in getting the exact result....
Click to expand...

That error may be due to the step you choose between each run. Example
First run: 1GHz - 3GHz with step 1000 but after that it is rechanged step to 500.
 
  • Like
Reactions: nvt088

    N

    nvt088

    Points: 2
    Helpful Answer Positive Rating
gemmy94 said:
That error may be due to the step you choose between each run. Example
First run: 1GHz - 3GHz with step 1000 but after that it is rechanged step to 500.
Click to expand...

Changing the frequency of simulation leads to new mesh-cells for your structure, so your results can be changed!!!
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top