Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[PrimeTime] Path and other modes

Status
Not open for further replies.
ivlsi

ivlsi

Advanced Member level 3
Advanced Member level 3
Joined
Feb 17, 2012
Messages
883
Helped
17
Reputation
32
Reaction score
16
Trophy points
1,298
Activity points
6,868
Hi All,

What modes PrimeTime can be run? What is 'path_mode'? How does it work?

Where can I see good complex examples about running PrimeTime?

Thank you!
 

Assuming you are speaking of PBA, this option is for reporting. Usually the reports are generated on graph based analysis and the numbers are pessimistic as the worst case transitions/delays are assumed.

In path based analysis, you trace the actual path and transitions resulting is accurate numbers but with a run time impact. Look up in Solvnet, there are very good materials regarding this.

Cheers
G1
 

    V

    Points: 2
    Helpful Answer Positive Rating
graph based analysis
Click to expand...
Can you tell more please about GPA? When should be it used? Why needed?

Are the PBA and GPA the same things? Is PBA just a report option while GPA is type of analysis?

Is GPA faster, but less accurate (more pessimistic) than PBA? Do GPA produce more false negative results, which should be then filtered out by PBA?

Unfortunately, I don't have an access to Solvnet. Can you share some materials or good examples from there?
 

Both are reporting options and use different path tracing algorithms.

GBA: This is fast, slightly pessimistic and uses worst values across each cell in the path.

PBA: More accurate, time consuming and uses exact path tracing and exact propagation values.

GBA is used for most of the design cycle and PBA is used towards the end close to tapeout. Create a Solvnet account, should take few minutes, I dont think they have PDF files which I can share.

Cheers
G1
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top