Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to draw jumper or no connection using PROTEUS 7 Professional

Status
Not open for further replies.
R

raju_kambar

Full Member level 3
Full Member level 3
Joined
Jun 19, 2013
Messages
153
Helped
5
Reputation
10
Reaction score
5
Trophy points
18
Location
Earth
Activity points
1,404
Dear Friends,
How to draw Jumper or no connection from one place to another place as shown in screen shot below red rings using PROTEUS 7 PROFESSIONAL.
Can you help me.
Jumper_Line_or_No_Connection_Example.jpg
 

bigdogguru said:
Simply draw one connection over the other, if there is no explicit node formed, there is no connection.
Click to expand...

I agree with you, but if we draw semi cirle like symbol as I shown in the screen shot of posting #1 to crossing one line on the other without connection of it, it looks nice.
How to draw semi circle like symbol, when one line crossing on the other without any connection using PROTEUS 7 Professional.
 

It is not necessary unless you configure the arrangement of your circuit. Proteus is built upon intelligent schematic capture component part. All lines will show as crossing but will only show a dot at connection points (nodes).
They use to have some environment settings in the user preference area that allows you to show the display mode when lines cross. I will advice you check those settings. Hope this helps.
 
logicon said:
They use to have some environment settings in the user preference area that allows you to show the display mode when lines cross. I will advice you check those settings.
Click to expand...

Some can suggest me, which environment setting is used to get the crossing lines as appear in the screen shot of posting #1.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top