Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sine wave generator in proteus

Status
Not open for further replies.
S

sunil21

Advanced Member level 4
Full Member level 1
Joined
Dec 2, 2010
Messages
119
Helped
4
Reputation
8
Reaction score
5
Trophy points
1,298
Activity points
2,514
I wish to know how to setup 230v source from proteus "Generators " - SINE.

I worked with dc well. now when I click SINE there are three fields to fill.
(I need 230 v ac, 50 hz and also to work with PIC I need 2.30v , 50hz source)



1.offset ?
2. amplitude/peak/RMS ?
3. Frequency (I think this is 50hz);

VSINE also works the same way with the same values ?

I searched in the internet but didn't find a suitable answer.
Kindly answer or point to some valuable links
 

Keep offset zero (0).
Set amplitude = 325V or Peak = (325 x 2)V or RMS = 230V, whichever you like.
Set frequency = 50Hz

Use same properties for VSINE also.
 

    Z

    Zeninth125

    Points: 2
    Helpful Answer Positive Rating
Thanks I will try
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top