Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Current reference source for a 2 stage operational amplifier

Status
Not open for further replies.
H

hobbyiclearner

Full Member level 2
Full Member level 2
Joined
Oct 27, 2014
Messages
142
Helped
2
Reputation
4
Reaction score
2
Trophy points
18
Activity points
1,296
Hello,

Can anyone suggest a simple current reference circuit for a two stage op amp. I need to generate constant current in uA range to be injected in the diode connected transistor and mirrored at both the stages.

Thanks,
Hobbyiclearner
 

Hi,

If you need a simple Current Source Reference independent of the supply voltage you can use the following scheme:

Reference Current Source.png

On the left the starting circuit is shown. The reference source circuit is on the right. Iref is the output current.

Greetings, I hope it meets your expectations.
 
Are there any references for the above circuit. Any books / name of the ckt etc.

Thanks.
 

This circuit is discussed in chapter 4 of the book Analog Design for CMOS VLSI Systems / Franco Maloberti.

4.2.3 Self Biased Micro-Current Generator
4.2.4 Start-up Circuits

* There is an error in the above scheme. The correct scheme is attached.Reference Current Source_V2.png
 

In Bakers book you can find a good description and info avout this circuit.
 

OK.. I will check them out and let you know.

Thanks,
Hobbyiclearner
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top