Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

3 Phase motor interface using triac

Status
Not open for further replies.
M

Murugesh_89

Full Member level 5
Full Member level 5
Joined
Nov 23, 2012
Messages
266
Helped
7
Reputation
12
Reaction score
6
Trophy points
1,298
Location
India
Activity points
3,267
Hi,

I would like to run a three phase motor using triac. Also i want to do using a single pin from the microcontroller ic.

I have attached the circuit as per my opinion.
TRIAC_3P MOTOR.jpg

I am new to this 3 phase motor control and all.

Please tell me whether this circuit is correct or not?

Also Please give your suggestion for the same.

Thanks,
Murugesh
 

There's no way to avoid three separate opto triacs. The present circuit will end up in a nice explosion.
 

Well thanks FvM.

I redesigned and attached here. Kindly give your comments for this new one.

TRIAC_3P MOTOR.jpg
 
Maximum specified trigger current for 3021 is 15 mA. Resistors should be corrected respectively.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top