Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

bc557 100khz frequency switching doubts

Status
Not open for further replies.
R

raman00084

Full Member level 6
Full Member level 6
Joined
Nov 29, 2010
Messages
375
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,076
from pic micro controller i am generating 100khz square wave signal. i am feeding the square wave to 6n136 optocoupler but the output of optocoupler is phase inverted in order to correct it i am using 557 transistor. my doubt is can i use 557 transistor for switching 100khz frequency is there any other way. i want to just optoisolate (separating two grounds) with the same phase of pic wave form.

regards
kalyan
 

Hi,

If you see the transistors datasheet its transition frequency is quoted a 100 Mhz Minimum so think as a simple inverter it will just about manage 100Khz.
 
Depends on your duty cycle requirements. You'll observe a certain asymmetry due to saturated switching.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top