Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Leave trim pin of 1v reference IC open is ok?

Status
Not open for further replies.
Yes, it says "TRIM/NC". That means that if you leave it unconnected the device will work without any external compensation.

Being curious, what application is that reference generator for?
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
it will form the control voltage for a led driver ic...the ref actually gets fed to a digital pot which divides it down as required.
so we have variable output current.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top