Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] SMPS output flickering

Status
Not open for further replies.
ismu

ismu

Full Member level 2
Full Member level 2
Joined
May 12, 2009
Messages
145
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
nil
Activity points
2,340
in my Tecktronics TDS100c model internal SMPS is from Emerson , it has been damaged , its TOP244yn IC is gone bad[smoke is there near] , so i replaced with new one , after that out put is coming 3.3v but it will on at 2sec and off at 2sec and repeating ,i didnt check other sections may same issue ., what should i change .see the picture ..
 

Attachments

  • 20140921_150122.jpg
    20140921_150122.jpg
    228.4 KB · Views: 172

i think there is a problem with current sense section
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
can suggest where is the current sense laction in top244yn ic or any related components ?
 

check the optoisolator and high watt resistors or replace th optoisolator if you have.
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
where will be the high wattage res? which one?can u check below picture , i think opto is 817
 

Attachments

  • 20140921_150122.jpg
    20140921_150122.jpg
    1.4 MB · Views: 167

can you post the backside of the pcb?
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
Hi,

have you cleaned the smoked part of the PCB properly? There might be slightly conductive residuals.
Or an old electrolytic capacitor,
or a lot of other reasons.


Klaus
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
yes , i cleaned well

- - - Updated - - -

in top244yn data sheet they mensioned reference design , can u refer that schematic and wich may be the resistor whch u have mensioed earlier? currently body is not with me ./
 

i suggest you to check all the resistors carefully (specially high watt resistors like R7,R8,R5 etc) and the diodes specially D6,D7 with multimeter
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
H all friends

i got the issue and now it is working fine , the problem was optocoupler has been damaged , i replaced it.

Thanks all [specially hamid159 ] for your valuable replay .

- - - Updated - - -
 

glad....your problem has solved.
 
  • Like
Reactions: ismu

    ismu

    ismu

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top