Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Code failure after schematic modification

Status
Not open for further replies.
M

Mzz Amin

Newbie level 5
Newbie level 5
Joined
Mar 18, 2014
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
86
I have saved my code using mikroc and it worked very well during the simulation using Proteus:ISIS. BUt, when i've added max 232 and reconnect virtual terminal but the simulation is no longer the same.
I've gotten a crypted message in the virtula terminal dispaly. what should i do ?
 

Please give more informations,about :where is the virtual connected? Before or after the max232 ?
I suggest you to use the phy COMPORT object in isis, then use a serial terminal like # termite for windows
Beware of inverted signals, between TTL and RS232 but i guess you know that.
 
Actually i did not know it becaus i am still an amateur the problem was about the inverted signals i found the solution, although that, i appereciate your help thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top