Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] capacitive power supply - microcontroller

Status
Not open for further replies.
bmandl

bmandl

Full Member level 4
Full Member level 4
Joined
Feb 26, 2010
Messages
210
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
Slovenia
Activity points
3,006
Hello guys,
I built this power supply for my microcontroller project (simple diode thermometer for my laminator project). But when I connect my mcu circuit to this power supply, it keep getting reset. If I use my lab power supply with 5V, it runs smootly. What could be the problem? I already tryed bigger filter capacitor (first 470uF, then 2200uF and now 3300uF) and result is the same.

- - - Updated - - -

Let me answer myself. 100nF decoupling capacitor did the trick :)
 

Let me answer myself. 100nF decoupling capacitor did the trick :)
Click to expand...
you mean when you replaced 1000uf capacitor with 100nf cap you got proper results??
 

No, I just added 100nF capacitor between +5V and GND. I had none before.
 

hmm..... you are using decoupling cap inorder to reduce the ripples i.e get a smooth dc supply(regulated) But even the zener diode is doing that job by keeping the voltage at a preffered level then too you faced problems!?
 

I am not using decoupling capacitor for filtering. I just added decoupling capacitor between +5V and GND on mcu board to solve problems with disturbances, which caused microcontroller to reset. Filter capacitor is on power supply pcb and is 470uF, as in beginning. Why you don't want to understand? Do I have to draw it? :D
 
lol..I will just decode the circuit : In your circuit you have used a 470uf as a filter capacitor to bypass ac component ok.. But, the voltage across this capacitor is not exactly 5v so you put a zener diode across it inorder to exactly regulate it to 5v.
PROPERTIES OF ZENER DIODE:
if you look in the datasheets of the zener diodes working at the voltage levels which you are using them at, The zener diodes are put in their noisy mode due to which they start injecting noise in your circuit and you have to place a decoupling capacitor.
Otherwise if you donot want to worry about these stuffs then just place a 7805 voltage regulator instead of zener diode and a decoupling capacitor you will get a clean dc supply. GOT IT?
 

Disha Karnataki said:
....you have to place a decoupling capacitor.
GOT IT?
Click to expand...
Yeah, yeah, we got it - no need to shout.
Actually, that's pretty much what the OP said in post 1. What's your point? Or are you just letting us know you finally figured out what's going on?
 
Last edited:

I have already told you my point. Again what you want me to tell??
 

by the way you just read last two sentences that is that you have to place a decoupling capacitor i gave him an alternative to it that is he can do so by using ic 7805
 

Yes, a 7805 would probably be better than a Zener, but it would also need a decoupling capacitor at the output.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top