Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to calculate the receiver dynamic range?

Status
Not open for further replies.

harmony

Member level 2
Member level 2
Joined
Oct 31, 2004
Messages
42
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
373
receiver dynamic range

hello
how to calculate the receiver dynamic range if i have the overall noise figure and the output signal to noise ratio ?

if anybody had a good paper/tutorial i d be thankful
 

calculations for receiver dynamic range

harmony said:
hello
how to calculate the receiver dynamic range if i have the overall noise figure and the output signal to noise ratio ?

if anybody had a good paper/tutorial i d be thankful

1st you need at least one more info, i.e. IP3, more exactly you must define what "type" of IP3: i.e. Two Tone Output IP3 (TTOIP3)

2nd:
The ratio between MDS and Two Tone signal Level whose Third order IM products are equal to MDS (then may be transformed in dB... 10 log...)
MDS=Minimum discernible signal = K Top B
K= Boltzmann Konstant
Top= Noise operative temperature (Te+Tantenna)
B= Bandwidth
All data on SI units

3rd: download the trial version of SysCalc. It perform calculations fast and it's fiendly.
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
dynamic range calculation of reciever

Maybe this is what you want .
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top