Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] MAX232 in Proteus simulation - no OUT signal

Status
Not open for further replies.
U

Under89

Newbie level 3
Newbie level 3
Joined
Nov 11, 2013
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
22
Hi ;-)

I'm trying to make a simulation of the Max232 with ATMega8 in Proteus 7.6.
Circuit diagram shown in the picture

1274051.jpg

Output signal from the ATMEGA seen on channel A.
Why there is no signal on channel B? (T1OUT)
(Hiddens pins are connected do Vcc(5V) and GND)

Thanks for your help
 
Last edited by a moderator:

asdasdasd.jpg

I corrected diagram but the problem still exists :(
 

Project files and .hex with program :wink:
 

Attachments

  • Max232 Atmega8 TEST.rar
    26.9 KB · Views: 139

Hey man out put is coming for your circuit... Please check your software... In my pc the op is coming... The op is amplified inverted input

- - - Updated - - -

Capture.JPG

SEE THE OP OF UR CIRCUIT
 
Wow :)
Thank You very much for testing my project. Now i see that i must reinstall Proteus, or install another version.
Fortunately, the problem was solved. Thanks ;)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top