Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

make a laser pointer

Status
Not open for further replies.
C

chri$

Member level 1
Member level 1
Joined
Jul 26, 2013
Messages
36
Helped
2
Reputation
4
Reaction score
2
Trophy points
8
Activity points
211
Hi everyone,

I'm about to make a laser pointer (red laser 1mW, alimentation min 3Vdc and current <60mA). So, here's my question. Can I just put 2 resistors ( the both are 10 ohm) and potentiometer (100 ohm) ? or I should add components like diodes and voltage regulator ?
 

You can just use resistors but most laser diodes also have a sensor in them to read the light level. With a simple external circuit you can control the current to ensure the diode says in it's laser mode regardless of battery voltage, as long at there is enough voltage of course!

Brian.
 
  • Like
Reactions: chri$

    C

    chri$

    Points: 2
    Helpful Answer Positive Rating
Low-cost laser pointers use the simple dropping resistor circuit. Open one and see for yourself. The more complex circuits are not designed for laser pointers but for optical fiber communication systems, need a higher supply voltage than 3 V.
 
  • Like
Reactions: chri$

    C

    chri$

    Points: 2
    Helpful Answer Positive Rating
Thanks for your replies.

I'll try with what I have.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top