Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

6V battery to +12V/300mA, -12V/300mA and +5V/2A DC-DC converter circuit

Status
Not open for further replies.
Jestin_cubetech

Jestin_cubetech

Advanced Member level 1
Advanced Member level 1
Joined
Jun 24, 2012
Messages
499
Helped
76
Reputation
152
Reaction score
73
Trophy points
1,328
Activity points
3,697
how can i design a LM2577-ADJ Fly-back Regulator for
6V battery to +12V/300mA, -12V/300mA and +5V/2A.



5v to +12V/300mA, -12V/300mA




i am trying to design 3 output power supply using single LM2577.

Any suggestions are greatly appreciated..
 

You can’t make the circuit with your specification.
For your requirement you need to drive 19VA (17.2VA in secondary) in the primary side with 6V. So the switching current will be 3.2A. It will exceed the current limit of the controller.
 

thank you smijesh
what about 12v battery ?
 

As per data sheet it will work.
Select transformer with primary inductance of 30 to 40uH and ratio of 1:1:0.5,
Put a heat sink for IC,
5V out should not be a regulated one.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top