Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What should i use S21 when matched to 50Ohms or pure S21 when choosing FET?

Status
Not open for further replies.
T

Terminator3

Advanced Member level 3
Advanced Member level 3
Joined
Feb 25, 2012
Messages
802
Helped
71
Reputation
142
Reaction score
63
Trophy points
1,308
Activity points
9,027
I am a little comfused about choosing best suitable transistor for certain S21 magnitude. What is the fast way of doing that? For now, i use s-parameters, then do simple match of gate to 50Ohms and see if s21 magnitude is enough. But maybe there is some other faster way, or rule. So i can just see at bare S-parameters in datasheet?
 

I am afraid you have to design matching network for every transistor. I will recommend to stick with your S21 as it is crucial. Moreover transistors with S11 or S22 (that u can see from its list) close to 50+0j at your desired frequency band will obviously need much simple matching network compared to the one with impedance greater than 50+0j. so the bottom line is you can a bit narrow down your search to the one whose S11 or S22 close to 50-Ohm.
this may u may save time in designing matching network.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top