Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Pin description of RF receiver RXB11

Status
Not open for further replies.
P

Pradeepbp

Junior Member level 2
Junior Member level 2
Joined
Sep 21, 2013
Messages
23
Helped
9
Reputation
18
Reaction score
9
Trophy points
3
Location
Kerala
Activity points
214
Hi,
I am working on RF project. I am using RXB11 RF receiver. It has got 8 pins, 2 pins at named as data pin. Please find attachement
rxb11 pin.jpg
My doubt is why 2 data pin? Which one to use as a data receiver pin.
 

The second pin is the digital data pin and the third one is the linear output(analog).You don't need to connect the third one.it is the demodulator output which gives us the signal strength.actually linear output pin is connected internally to a data slicer circuit which determines the logic voltage at pin 2.if the linear output is greater than the referance we get a logic high at pin 2 otherwise a logic zero.note that the linear output decreases with increase in distance and therefore lose of data bits occurs.
 
Hi S.P.S,
Thanks for the info. When you say 2nd pin, I assume its data pin next to GND.

I have one more question.
I believe that whatever data I send at data pin of transmitter, is available at data pin(pin2) of receiver. We dont have to bother about demodulation or modulation.
Suppose while transferring a data from a port pin of micro-controller to another port-pin of a microcontroller, instead of a wire, i can put this transmitter and receiver in between and connect the port pin of first MC to Tx data pin and port pin of second MC to data pin of receiver. And it works as before.
Am i correct??
 

Yes it is the data pin next to GND.Just don't care what i told about the third pin.you just have to connect the second PIN directly to the MCU RX pin.If you get some random values use lower baud rates.Yes, you can replace a wire connection by simply connecting the pair.the only matter is the baud rate.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top