Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

dsPIC build error code

Status
Not open for further replies.

P.Copper

Member level 5
Member level 5
Joined
Mar 18, 2013
Messages
82
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,807
Hi all

I'm running a dsPIC30f4013 with MPLAB X IDEv1.60. when i try to build my code it gives me this error code

"Target Device ID (0x0) does not match expected Device ID (0x1410000)"

If anyone has encounted a similar problem help will surely be appreciated. thanks
 

Hi P.Copper,
I too experienced the same problem while using pickit 3. I sometimes turn-off the devices(including PICkit) and then restart it. But later I came to know that, it was due to the fault in the design which caused wrong voltage levels in the PGD and PGC. This was due to a faulty CAN TxRx IC connected to the same PGD and PGC pin used for flashing. So it caused error in the initialization of connection between the PICkit 3 and the controller. After it was corrected, there was no further error happened while flashing.
So I think you better check the connection with the controller and PICkit 3 and compare with the requirements...
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top