Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to rout protective earth through a board? Need advice

Status
Not open for further replies.
S

swen_s

Member level 1
Member level 1
Joined
Nov 29, 2012
Messages
40
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,598
On my board i have ground and protective earth. Protective earth is only connected to the mounting holes of the board, it is not connected to ground.

Is it wise to have a separate plane for the protective earth to connect all mounting holes together?

Or is is bad to have protective earth go through the board in the first place?

Would it decouple noise (ESD) to the nearest plane (for example ground plane)?

Where can I find more information about how to handle this?
 

Why at all do you want to route PE across the board?

Apart from this point, EMC considerations often suggest to connect a decoupling capacitor between circuit ground and PE, but I don't know if it's appropriate for your design.
 
  • Like
Reactions: IanP

    I

    IanP

    Points: 2
    Helpful Answer Positive Rating
FvM said:
Why at all do you want to route PE across the board?

Apart from this point, EMC considerations often suggest to connect a decoupling capacitor between circuit ground and PE, but I don't know if it's appropriate for your design.
Click to expand...

The customer want it that way.
 
  • Like
Reactions: IanP

    I

    IanP

    Points: 2
    Helpful Answer Positive Rating
The old adage "The customer is always right" is not always correct - especially with PCB design:)
 

There might be reasons to route PE over PCB, but without knowing the particular requirements, it's hard to discuss.

I remember a design, where low inductance decoupling between PE (metallic case) and circuit ground was intended, the solution was a PE copper pour overlapping the ground plane. But in another design, you may want low capacitance between ground and PE...
 

Personally, all the designs I have seen in the last several years have usually had the board 'ground' connected to the PE by a largish SMD capacitor (large to get the spacing between the pads). And there is a distinct isolation area between any PE connections on board and the rest of the circuitry. Having a PE plane will couple this capacitively to all sorts of signals, or the board ground if that is the nest plane, not a good idea for EMC. I recently did some boards that had to be immune up to 18GHz susceptibility and had an RF engineer advice on all aspects of the design from layout to filters chosen.
Don't forget some EMC engineers call PE the noise distribution network.
 

Talking about "PE" without referring to a real instrument design is about to meaningless, I fear. In so far I won't contradict your comment, just say, there are different cases as well.
 

I agree, one of Henry Otts papers refers to a screen plane under the ground plane. But with todays high frequency noise having two planes (PE and GND) is going to couple HF RF noise capacitivly.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top