Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle pro..How do i get rid of "DrillLegend" debris

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,

I deleted a 7 way PTH connector.....for some reason its "drilllegend" debris is still left there on the pcb...how do i get rid of it?....Is there a danger that the pcb manufacturer may drill unwanted holes there?
 

I haven't seen that problem. Have you a screenshot? You can always check the Gerbers/NC Drill files to make sure there isn't anything that shouldn't be there.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Re: Eagle pro..How do i get rid of "DrillLegend" debris

I've seen that too but it goes away if I close and re-open the file.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
i dont know how to view the drill holes...the gerbers dont show the drill holes....NC drill files wont show in gerbers i find
 

If you import the drill file into GCprevue (free) along with the Gerbers then it will show the holes and if you click on the holes and query them (hit the letter Q) it will also show the size.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Thansk Keith,
I havebeen using viewmate so that sounds like my problem
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top