Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

altium designer-gerber file

Status
Not open for further replies.
deepsetan

deepsetan

Advanced Member level 4
Full Member level 1
Joined
May 8, 2013
Messages
119
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,298
Location
Malaysia
Activity points
2,137
when i convert my circuit into gerber file,it became like this(circuit 2)..does anyone know how to fix it?
 

Attachments

  • circuit 1.png
    circuit 1.png
    75.5 KB · Views: 113
  • circuit 2.png
    circuit 2.png
    43.7 KB · Views: 109

Which layer gerber you generated? what are all missing?
Can you please elaborate?
 

Hi,
I guess you have generated gerber for only bottom layer.
While generating gerber select layer tab thier select the layers which & all you want to be included in gerber or simply select used ON by clicking on plot layers.

Regards,
Anil
 
Your power tracks are rather thin, and in several places signals swap layers where they don't have to.
 

thanks man..it works..:-D

- - - Updated - - -

marce,what do you mean?..

- - - Updated - - -

this is my gerber file..i just need the bottom layer..is this seems correct?,what about the jumper?
 

Attachments

  • Untitled.png
    Untitled.png
    53.9 KB · Views: 89

hi deepsetan,
why did you kept more space for your board.please change the placement and reduce the size of board

- - - Updated - - -

hi deepsetan,
why did you kept more space for your board.please change the placement and reduce the size of board
 

ya.do the placement properly for example:led should be in edge of board and connector and switch also
 

You will have supplies going to the chips and a 0V (GND) signal, these tracks are the same width as the signal tracks, it is better to make them larger.
Also as I said earlier you change layers in some places where there is no need to.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top