Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] What is maximum frequency of CAN Bus?

Status
Not open for further replies.
mishrashashi

mishrashashi

Advanced Member level 4
Full Member level 1
Joined
Jan 5, 2011
Messages
105
Helped
20
Reputation
40
Reaction score
20
Trophy points
1,298
Location
India
Activity points
1,912
Hi,
What is the maximum/operating frequency of CAN (Control Area Network) Bus?
 

Hi,

the maximum baud rate of CAN bus is 1 Mbps as defined in the Bosch standard. In order to implement the CAN sampling/synchronization algorithm though, you usually need to have a higher frequency clock in your design (e.g. 16 MHz).

Please note that the baud rate of CAN is not dynamically configurable. If you want to change it you have to reset the CAN controller and all the devices on the bus and apply new baud-rate settings for all of them.

Regards,
Giorgos P.


mishrashashi said:
Hi,
What is the maximum/operating frequency of CAN (Control Area Network) Bus?
Click to expand...
 
Yes - 1 Mbits/sec.
Note that to get it to do that, you have to pay attention to using twisted pairs for signalling.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top