Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Altium : Converting 45 Routing bands into Arc Routing

Status
Not open for further replies.
P

PCB Designers

Member level 3
Member level 3
Joined
Dec 17, 2009
Messages
65
Helped
6
Reputation
12
Reaction score
8
Trophy points
1,288
Location
Karachi, Pakistan
Activity points
1,700
Dear all,

I am a user of Altium Designer Summer 09.

I have routed a board on 45 degree bands. Now, I want to convert these 45 degree bands into Arcs. I have searched, but unable to find a way out.

(In PCAD 200X) there was a tool named as "Mitor". We used it a lot, to do the same; but in Altium, I am searching for a solution)

Looking forward for your comprehensive responses.

Kind Regards,
Maqbool
 

Press SHIFT + SPACEBAR for arc while routing
 

Thank you very much Anil,

It helped me a lot.

I found that after running the utility, it is not possible to undo it.

What I am thinking to rewrite a script in VB with some selection/filter (Layer, netclass, bend size) menus for specific operations, in near future.

Hopefully, I will bother you for that also :smile:

Thank you again dear.

Regards,
Maqbool

anilrock87 said:
Hi,
Run the attached script this will convert the 45 degree track to arcs.

Regards,
Anil
Click to expand...

- - - Updated - - -

Thank you, but I asked about a board that has been routed on 45 Degrees.

Regards,
Maqbool

hemnath said:
Press SHIFT + SPACEBAR for arc while routing
Click to expand...
 

marce said:
Why do you want arcs instead of 45 degrees?
Click to expand...

I work on Xilinx Load/Test Boards. These are boards with high speed interfaces.

Also there are some test Platforms : Teradyne J750, Credence Sapphire, Teradyne Integra Flex, Agilent V93K etc

A 90 Degree or 45 Degree Band increases the width of Track at point of Band for a very short period. It increases the reflection and signal rise time. It behaves like a capacitive load with the transmission line. Round corner maintains the width of the track and is good for the health of high speed signals.

Regards,
Maqbool
 
Last edited:

Only if your in the gigaHz otherwise it does not make any difference...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top