Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] 8051 port 0 pullup resistors

Status
Not open for further replies.
V

vreg

Member level 4
Member level 4
Joined
Oct 16, 2012
Messages
70
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,935
Hi, I'm using Atmel's 8051 AT89C51RE2 for a microcontroller application

Do I need to provide pull up resistors if I'm using port 0, or is it only for specific type of applications?
Can I continue using port 0 like any other port after providing pullup resistors to each pin?
 

NYou have to give pull-up resistors whenever you are using port 0.
You can only use it after that. If no pull up resistors given, it wont work
 
shigha said:
NYou have to give pull-up resistors whenever you are using port 0.
You can only use it after that. If no pull up resistors given, it wont work
Click to expand...

Can I use it like any other port after connecting resistors?
 

Hope u got ur answer
 

I am using port pins (2.0 to 2.7) as output lines . is it required to connect pull up resistors along these lines ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top