vinu gopalakrishnan
Member level 1
hi friends, given below is the photo(bottom side) of my igbt h bridge for inverter. maximum current of 8 to 10 amperes will flow through. Will the soldering track carry that much current?
also i am planning to solder the snubber circuit into the same board, as i dont want to use a lot of wires and make it messy.
IGBT used : 15n120 (1200v,30A)
also i am planning to solder the snubber circuit into the same board, as i dont want to use a lot of wires and make it messy.
IGBT used : 15n120 (1200v,30A)