Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST frequency range problem

Status
Not open for further replies.
D

deepakonduty

Newbie level 3
Newbie level 3
Joined
Dec 17, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
Hi all,

When i simulate my design in CST in the frequency range 2-6GHz, i m getting good S11 result. When i change the range to 0-6GHz, i get different S11 values at the same frequency! can anyone please explain why is this happening?

Thanks
 

I think the mesh is calculated at the middle frequency of the frequency range. This 4Ghz in first case and 3GHz in the second one, thus you have a different mesh which could lead to different solutions. However this should not happen, so could try to increase the mesh density.

And you could search in the forum - this topic hast some threads. For example:
https://www.edaboard.com/threads/155108/
https://www.edaboard.com/threads/139165/
 
thanks a lot for the reply :-D..problem has been solved.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top