Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle Pro...components not being "replaced"

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,

I have just changed all my library component lettering to "vector" font, so that they print in the right place.

However, when i go to the schematic, and click a component, and then go "replace", and point to the part i want to replace it with, it doens replace.....the "value" in the schematic stays as "proportional" font as described in the "attribute" window.

Why is my "replace" not working?

Also, i tried "update", and the components did not update to the vector font ones that are in the library...do you know why?
 

Try adding a new component of that type and it should look like your new library part, then delete the original. I have had this happen myself and it does seem illogical but it works.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Also, try "update library" rather than "replace".

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top