Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to design clylinderical arcs

Status
Not open for further replies.
fussylogia

fussylogia

Newbie level 5
Newbie level 5
Joined
Nov 20, 2004
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
74
I am currently beginner user in HFSS and i am trying to design birdcage coil. How can I design strips on the inner face of clylindirical surface? Is there any utility to cut arcs from cylindirical surface?
e.g: How can I cut 12 equal strips from a cylinder surface? I am uploading a sample view of coil.
 

For cutting 12 equal strips, first make one strip(in the form of box).Duplicate it by using angle of 30 degrees 12 times. Then select the cylinder and all the 12 strips. Choose intersection from the boolean.

Actually I could not see the figure that u supplied coz of lesser points...hope to provide more details after seeing it!
 

    fussylogia

    fussylogia

    Points: 2
    Helpful Answer Positive Rating
I just saw the figure.I think that above reply should solve ur problem. Take care about upper and lower rings...either u can draw after intersecting the strips...and later join them by using boolean..
 

    fussylogia

    fussylogia

    Points: 2
    Helpful Answer Positive Rating
edit> duplicate> around axis ,

draw >sweep> around axis,

focus over it and try !
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top