Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] MOSFET control problem

Status
Not open for further replies.

dxtr

Member level 3
Member level 3
Joined
Apr 27, 2012
Messages
66
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,699
Hey everybody
i wanna simulate a chopper using mosfet but i can't get it to work.

i used NE555 to generate pwm signal
here is the result

**broken link removed**


why i don't get a a chopped signal between 0 and 100v
 
Last edited:

The scope trace alternates between 96.7 and 100.2 V. I believe you expected it to alternate between 0V and 100V.

I think it will resemble that if you were to add a load, with the other end connected to zero ground.

Since a voltage will appear across it, this may change the gate-to-source differential...
which may change the internal resistance of the mosfet...
which may change the voltage on the load, etc.
 
  • Like
Reactions: dxtr

    dxtr

    Points: 2
    Helpful Answer Positive Rating
Try connecting the Source pin of MOSFET to gnd. Right now i can't figure where it's going. Whats the <arrow> and '+' symbol mean ??
And a Voltmeter is certainly not gnd.

And of course some sort of load R on the drain going to the supply positive.
 
  • Like
Reactions: dxtr

    dxtr

    Points: 2
    Helpful Answer Positive Rating
And a Voltmeter is certainly not gnd.

And of course some sort of load R on the drain going to the supply positive.

Thank you , it works now :)
another question , is there any circuit to trace the average of the chopped signal ?
 

..is there any circuit to trace the average of the chopped signal ?

you can try your voltmeter (an actual physical one.. not a simulated one) between Drain and Gnd. Set it to read DC volts. This will give you an approximate idea of the average voltage.
 
  • Like
Reactions: dxtr

    dxtr

    Points: 2
    Helpful Answer Positive Rating
you can try your voltmeter (an actual physical one.. not a simulated one) between Drain and Gnd. Set it to read DC volts. This will give you an approximate idea of the average voltage.
thats good , but i want the average value , i want a physical circuit if possible !
 

thats good , but i want the average value , i want a physical circuit if possible !

If you mean a simulated physical circuit...
:^)

Add a high ohm resistor and a low value capacitor, to get an averaged reading.

Screenshot:



The 10V pulses come at 70% duty cycle. The average is 7V.
 

If you mean a simulated physical circuit...
:^)

Add a high ohm resistor and a low value capacitor, to get an averaged reading.

Screenshot:



The 10V pulses come at 70% duty cycle. The average is 7V.
Thank you so much :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top