Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

"ECAN" pin's of dsPIC33EP256MU810 (or) dsPIC24EP256GU810

Status
Not open for further replies.
Hi,

Think thats is because its down to you what pins the Can modules uses.

See the datasheet PPS section register RPINR26 on page 224.
 
As wp100 indicated many of the peripheral module I/O must be mapped to a specific physical pin of the device.

This approach allows the device to offer many different peripheral modules, while conserving the number of require port pins to only those peripheral modules utilized.

The required techniques of mapping are covered in the following reference:

Section 30. I/O Ports with Peripheral Pin Select (PPS)

The dsPIC33 series also shares many of the features offered by the PIC24H series:

Engscope Tutorial - 05 Inputs and Outputs

BigDog
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top