Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PC Based Oscilloscope - USB

Status
Not open for further replies.
J

jonw0224

Full Member level 4
Full Member level 4
Joined
Nov 22, 2004
Messages
211
Helped
45
Reputation
90
Reaction score
14
Trophy points
1,298
Location
USA
Activity points
2,528
Several years ago, I posted a link to a PC Based Oscilloscope project I was working on.

https://www.edaboard.com/threads/79472/

There was some interest, however, most of the requests were for a USB connected oscilloscope. Well, I finally got around to incorporating USB into the project. Here is the project page.

**broken link removed**

Hopefully it will be of interest. Thanks,

-Jonathan
 

Great........Thank You....
I'll check it.........
 

Hello Jonathan, I wanted to say thank you for sharing your design; I assemble one some 2 years ago and so far works without any problem.

Thank you very much!

Greetings!
 

I take it it is possible to leave out the signal generator part of this circuit and just use it purely an oscilloscope?
 

Yes. The signal generator is a secondary board. The PCB layouts and the schematics exclude the signal generator and I've separated the signal generator into a seperate project.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top