Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

180 Hybrid Coupler at 20Ghz

Status
Not open for further replies.
G

GSarris

Member level 1
Member level 1
Joined
Mar 27, 2009
Messages
41
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Netherlands
Activity points
1,616
Hey guys
I am designing a 180 hybrid (rat race) on 20Ghz. My choices are microstrip or CPW. Any ideas on what i should choose? Also any idea a about the effects on different dielectric thickneses? Any prior experience or references are welcom. Thank you in advance.
George
 

At 20GHz, for a rat race coupler you can use any low-k substrate. The FR-4 Teflon substrate is good and low-loss.
Substrate thickness is not too important; the active lines width depends on it, this is all.
 

20GHz use FR4? the problem is FR4's Er is not consistence.
 

tony_lth said:
20GHz use FR4? the problem is FR4's Er is not consistence.
Click to expand...

If you think so... I have not tested FR-4 for such inconsistence, but I have used 20-mil 50-Ohm strips at over 90 GHz without problems. I have not tried to make a rat race on it.
 

volker_muehlhaus said:
What do you mean by FR4 Teflon substrate?
FR4 uses high loss dielectrics, whereas teflon substrates are low loss. Very different materials.
Click to expand...

You are right, I misfired ! For a long time I used Rogers substrates put in a box labeled FR-4.
Sorry, i must correct my box labels as well as my wrong advice.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top