Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The thing is my hardware is stopped working. I think my uC is not with us now ... alas... I was just reaching to the destination and this happened...
By the way i have ordered for the fresh-one i will get is to evening and i will start working on it.....
Thank you so much all your help... Sir alexan_e and Sir madhu you people are so help full..
If people like you all are there, no student will feel lonely in the World Of Electronics, no buddy will hate Electronics and IMPOSSIBLE like word will vanish from the dictionary... And yes if there is any further difficulty i'll defiantly come back to you people... if any one has any difficulty in this topic can write it here also... We will try to find the problem... Thank you ones again...
Did this happen while trying to write new fuse values?
Any chance you have applied wrong values to the fuses?
If you select the wrong source or disable ISP or reset this can happen.
may be sir i made the configure AVR clk and clicked on write all....
and i didn't got the response.
after that i clicked the check box given below the low fuse and high fuse and written by the option given in the on the same form
no response was coming from that time the previous program is also not working Sir...
Ismail
You have probably locked yourself out using the wrong setting.
If you have disabled ISP or reset then you need a parallel programmer to unlock it (or jtag I think)
If you have just applied a wrong setting like external clock then all you need is to apply an external clock.
A device like **broken link removed** can restore a device that has been set with wrong fuses.
@madhu
Yes sir... i am using ISP programmer...
USBasp
Ismail...
- - - Updated - - -
@alex...
Sir i have seen the site... but few thing is not understandable...
1) What is Brown-out detection
2) Boot Reset vector
3) CKOPT fuse
and some startup time is also mentioned there...
Guide me please...
Ismail
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
