Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Corner PADs are not fitted in SoC Encounter.

Status
Not open for further replies.
K

kopern1k

Newbie level 4
Newbie level 4
Joined
May 25, 2012
Messages
7
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,283
Activity points
1,332
Hi, guys.

I have the following problem. My netlsit have a group of pads that have also 4 corner pads. When I load the design in Encounter it includes corner pads together with other pads. And I'm not able to drag them in corner places because when I let my mouse go this pad slips out to the closest side place.

So what I should do with my code to fix this.


Thanks in advance.
 

kopern1k said:
Hi, guys.

I have the following problem. My netlsit have a group of pads that have also 4 corner pads. When I load the design in Encounter it includes corner pads together with other pads. And I'm not able to drag them in corner places because when I let my mouse go this pad slips out to the closest side place.

So what I should do with my code to fix this.


Thanks in advance.
Click to expand...

hi..
check in ur io file that u have mention this sides
Pad: c0 SW
Pad: c1 NW
Pad: c2 NE
Pad: c3 SE
 
Hai kop,
Ya mano is right.

If u still couldnt get then add the below command in lef file for the macro pad

CLASS ENDCAP BOTTOMLEFT ;

:razz:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top